HidFast Decker Tool

Hid Fast Deck Board Installation Tool

The gun the pro's use!

With the HIDfast Decker, you can stay on your feet and install boards quickly. You can install 8 deck boards in just 3 minutes. 100 sq. ft. = 10 minutes Directions: Place two 25 piece clips into HIDfast Decker. Place the Decker at the edge of deck board at each joist and lightly strike rubber trigger cap on Decker tool. One fastener per joist. Hammer the next deck board onto the short point of the fastener. For use with square edge, single or double groove and double groove. Designed for AZEK DECKING but may also be used with the following decking types: •Square edge: Azek decking, cedar, cypress, fir, mahogany, redwood, purewood or other thermally modified decking •Single or double groove: Cedar, cypress, fir, mahogany, redwood, purewood or other thermally modified decking, pvc decking •Double groove: Batu, garapa gold, IPE, Teak and similar wood types, composite decking Use HF2.5 or HF3 fasteners. For composite decking use only HF2.5. All grooved boards require the use of joist tool attachment.

MUST USE HIDfast NAILS. SINGLE PACK CONTAINS 175 STAINLESS STEEL FASTENERS. NOT INCLUDED. 

The First Air Driven Hidden Fastener Decking System. The Best Labor savings on the Market! It's easy as - load - shoot - tap!

Works with virtually all decking!

• Wood
• Azek
• Cedar
• Cypress
• Fir
• Mahogany
• Redwood
• Composite
• PVC
• Square Edge
• Grooved Edge
• Tongue and Groove
• Timbertech (composite decking needs to have a grooved edge. We recommend using our HF3M for a 3/16” gap between decking. The footplate will need to be adjusted so that the next board fits tight under the short point of our fasteners. The accuracy and speed of this gun make the difference.The way in which every fastener is shot into the hardiest center of each joist) 

The guide on the gun lines it up perfect every time. When it comes to speed there is no comparison. You walk along the joist swinging the mallet. As fast as you can move you can install, with hidden fasteners. One fastener per joist, no pouches full of screws. What makes the HID-fast system so fast? Pure and simple, there is NO hardware! No screws, no clips, no clamps. How about 30 seconds per board? If that sounds unrealistic, then you need to watch our videos and see for yourself. All you need is our pneumatic tool, a package of HID-fast fasteners, and our rubber mallet that comes with the tool, and you're ready to go. Now you can install decking 5 times faster than conventional screws, or nails. 

DETAILS:

• HIDfast can install 8 boards 8 feet long in a little over 3 minutes. Conventional 2.5-inch deck screws installed with a cordless driver will install1.5 boards in the same time as above. 
• HIDfast can do approximately 100 square feet in 10 minutes.
• HIDfast can be over 80% faster than a conventional installation. 

Click HERE for more information.

Click HERE for Fasteners.

Click HERE for Joist Attachment:

Installing Ipe decking: